Activity Stream - Bimmerforums - The Ultimate BMW Forum (2025)

New Activity ()

Please reload this page to view the 200+ new activity items that have been created.

• Older Activity

• 

  Today,09:03 AM

  sleuth255 replied to a thread 2003 530i crank, no start help needed in 1996 - 2003 (E39)

  VMware Fusion Pro. Its now free for personal use.

  see more

  21 replies | 533 view(s)

• 

  Today,09:03 AM

  Kamz e34 started a thread E34 manual swap in 1988 - 1996 (E34)

  Hello everyone, i am having some problems with my e34 525i m20b25 transmission, so i am thinking of doing a manual swap, which transmission would be...

  see more

  0 replies | 0 view(s)

• 

  Today,08:43 AM

  JMCLuimni replied to a thread P0440 Code E38 740iL now what in General BMW Mechanical Help sponsored by RM European Auto Parts

  I mentioned in original post…. “Damp with fuel”. I’ve never noticed damp fuel at the back of a gas cap on other vehicles…

  see more

  2 replies | 74 view(s)

• 

  Today,08:37 AM

  MarcoZandrini replied to a thread P0440 Code E38 740iL now what in General BMW Mechanical Help sponsored by RM European Auto Parts

  Damp with what? Water? Gas? That would be my first issue. I’m not ordering if there’s water in the evaporator system.

  see more

  2 replies | 74 view(s)

• 

  Today,08:33 AM

  Annddrriy replied to a thread E32 735 hard starting, bad cylinder identification sensor? in 1988 - 1994 (E32)

  If would not so important resistance in spark plug then Tim would not explain about the strangest ignition system in the world. If spark plug Bosh...

  see more

  115 replies | 3745 view(s)

• 

  Today,08:10 AM

  Annddrriy replied to a thread E32 735 hard starting, bad cylinder identification sensor? in 1988 - 1994 (E32)

  Do you have any spark plug part number with 1 kohm resistance ? The engine will run with those spark plugs Bosh W8LCR/W8LPR+ but injector timing will...

  see more

  115 replies | 3745 view(s)

• 

  Today,07:53 AM

  azdk99 replied to a thread E38 Battery Drain, It's Real! in 1995 - 2001 (E38)

  UPDATE Replacement Lighting Control Module installed. Battery drain is the same I'm running out of ideas. Sent from my ELE-L29 using...

  see more

  20 replies | 709 view(s)

• 

  Today,07:44 AM

  robb1887 replied to a thread We need more build threads: 00 Z3MC SG/DBO in 1996 - 2002 Z3 (E36/7, E36/8)

  Josh's kit was amazing, no doubt. I did only send the blower and nose drive to Jon Bond, so the kudos should be headed towards HPS (the tangent...

  see more

  545 replies | 157363 view(s)

• 

  Today,07:22 AM

  LilBlueWagon replied to a thread Rock hard radiator hoses in 1988 - 1996 (E34)

  No, temp gauge either just below or just on midway line. There is some kind of buffering in temps so the temp gauge stays pretty much in the...

  see more

  2 replies | 95 view(s)

• 

  Today,06:23 AM

  Annddrriy replied to a thread E32 735 hard starting, bad cylinder identification sensor? in 1988 - 1994 (E32)

  M4 type ignition spark plug long boot will not fit to new type of the spark plug. NGK R spark plug will fit to M4 ignition spark plug long boot on...

  see more

  115 replies | 3745 view(s)

• 

  Today,06:17 AM

  Annddrriy replied to a thread E32 735 hard starting, bad cylinder identification sensor? in 1988 - 1994 (E32)

  You are correct the part shown in my pictures is the angled boot which goes into the distributor cap not on the spark plug. This is just a sample....

  see more

  115 replies | 3745 view(s)

• 

  Today,06:11 AM

  shogun replied to a thread E32 735 hard starting, bad cylinder identification sensor? in 1988 - 1994 (E32)

  the part shown in your pictures is the angled boot which goes into the distributor, not on the spark plug. The one for the M30 spark plug is a...

  see more

  115 replies | 3745 view(s)

• 

  Today,05:31 AM

  Annddrriy replied to a thread E32 735 hard starting, bad cylinder identification sensor? in 1988 - 1994 (E32)

  It will be difficult to find spark plug with 1000 ohms resistance which fits to the old type ignition wire spark plug end. All new type of the spark...

  see more

  115 replies | 3745 view(s)

• 

  Today,05:29 AM

  Panamera1988 replied to a thread Best suspension for e38 with self leveling in 1995 - 2001 (E38)

  I need your opinion, if I install OEM shocks with Eibach ProKit, would the quality of the ride be noticeable against OEM springs? I mean would it be...

  see more

  18 replies | 675 view(s)

• 

  Today,03:29 AM

  SW530 replied to a thread Need some advice rebuilding a m62tu out of a 1999 540i in 1996 - 2003 (E39)

  I didn't read all the replies, but it's good to see such a great response. I have a fair amount of experience rebuilding motors, mostly iron...

  see more

  19 replies | 475 view(s)

• 

  Today,02:30 AM

  DomK started a thread E30 BMW E30 Euro-Spec H4 H1 Sealed Beam Headlight Set in

  These are the more attractive European cousin to the North-American Market sealed beams found on the 1984-1992 BMW 3 series, aptly known as the...

  see more

  0 replies | 42 view(s)

• 

  Today,02:22 AM

  cirrusblau replied to a thread Rock hard radiator hoses in 1988 - 1996 (E34)

  Oil and water/coolant will not mix if combustion is leaking into the cooling system. How's your temp? Is it overheating?

  see more

  2 replies | 95 view(s)

• 

  Today,02:21 AM

  cirrusblau replied to a thread Clutch master cylinder replacement in 1988 - 1996 (E34)

  Is this the plastic elbow on the master where the hose connects to? Any idea why yours cracked? The reason I'm asking is I've had this elbow crack on...

  see more

  4 replies | 330 view(s)

• 

  Today,02:10 AM

  82eye replied to a thread Brakes for S52-swap... in 1983 - 1991 (E30)

  no, 16s seem to get mentioned with bbk all the time.

  see more

  5 replies | 185 view(s)

• 

  Today,02:07 AM

  fortunateson replied to a thread Can’t access “oil reset”... in 1996 - 2003 (E39)

  Stupid me turned the key before pressing the odometer button! I’ve done the correct procedure many times but I goofed this time....

  see more

  4 replies | 77 view(s)